Roland maxWerk Musical Instrument - Manual (Page 72)

72
Editing in the Phrase Scope
Editing the Pitch/Time/Formant/Dynamics
Here’s how to edit the Pitch/Time/Formant/Dynamics in the specified region of the phrase.
1. Select the parameter that you want to edit.
At the left of the controller display area, press one of the [Controller select] buttons to select the
parameter you want to edit: [PITCH] , [TIME] , [FORMANT] , or [DYNAMICS] .
* You cannot edit the formant if the sample was encoded in a type other than “SOLO.” Even if you press
the FORMANT button, the red line indicating the formant will not be displayed.
2. Use one of the following methods to specify the region that you want to edit.
3. Use the [Curve select] buttons to select the type of curve.
fig.03-ps03
You can select one of three curves to specify how the parameter will change. Click
either the Flat, Linear, or Rounded curve button.
● Flat : The parameter will be increased or decreased equally.
● Linear : The parameter will be increased or decreased in a straight line.
PITCH (Control change number 16) Varies the pitch.
TIME (control change number 17) Varies the playback speed.
FORMANT (control change number 18)
If the sample was encoded as “SOLO,” varies the
tonal character (formant).
DYNAMICS (control change number 11 Expression) Varies the volume.
To select a desired region
Drag the mouse to left or right in the controller display area . To se-
lect a region in grid units, turn on the Grid Snap button.
To extend the selected region
Hold down the [Shift] key of your keyboard and click in the control-
ler display area .
To select an event Click the waveform display area .
To select multiple events Drag the mouse to left or right in the waveform display area .
To cancel your selection
Click in an unselected part of the controller display area , or click the
border.