Roland maxWerk Musical Instrument - Manual (Page 34)

34
Installation
■ Connections and OMS setup
Installing the VariOS OMS driver
Use the following procedure to install the VariOS driver.
The included
VariOS OMS Driver-E is an add-on module for using the
VariOS with OMS. In order for you to use it, OMS must already be
installed on the hard disk from which you started up .
* Disconnect the VariOS from the Macintosh before you perform the installation.
1
Exit all currently running software (applications).
2
Insert the CD-ROM into the CD-ROM drive.
3
Double-click the VariOS OMS Driver-E Installer icon (found in the
English - Driver - VariOS OMS Driver-E folder of the CD-ROM) to start
up the installer.
4
Verify the [Install Location] , and click [Install] .
fig.3-2
5
If a message like the following is
displayed, click
[Continue] .
The other currently running
applications will exit, and installation
will continue.
6
A dialog box will indicate Installation completed.
Click [Restart] to restart your Macintosh.
If you are using a virus
checker or similar software,
be sure to exit this as well.