Roland Fantom-S88 - Manual (Page 94)

94
Creating a Performance
Type (Assignable Type)
Specifies the function controlled by the D Beam controller.
Value
CC01–31, 33–95: Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to “MIDI Implementation” (Parameter List).
Bend Up: Raises the pitch in semitone steps
(up to 4 octaves higher).
Bend Down: Lowers the pitch in semitone steps
(up to 4 octaves lower).
Start/Stop: Starts/Stops the sequencer.
TAP Tempo: Tap tempo
(a tempo specified by the interval at which you
move your hand over the D Beam controller).
Arp Grid: Arpeggio Grid
Arp Duration: Arpeggio Duration
Arp Motif: Arpeggio Motif
Arp Oct Up: The range in which the arpeggio is sounded will
rise in steps of an octave (maximum 3 octaves).
Arp Oct Down: The range in which the arpeggio is sounded will
lower in steps of an octave (maximum 3 octaves).
Range Min (D Beam Range Lower)
Specify the lower limit of the range of the D Beam controller.
Value: 0–127
Range Max (D Beam Range Upper)
Specify the upper limit of the range of the D Beam controller.
By setting Range Max below Range Min you can invert the range of
change.
Value: 0–127
Knob
fig.06-17_50
For details on the setting, refer to “Selecting the Parameter
Controlled by the Realtime Controllers or D Beam Controller
(Control Setting)” (p. 91).
Knob parameters are valid only when the REALTIME
CONTROL button is set to “ASSIGNABLE.”
Knob Assign 1–4
(Realtime Control Knob Assign 1–4)
Specify the functions that will be controlled by the [ ] knobs.
Value
CC01–31, 33–95: Controller numbers 1–31, 33–95
For more information about Control Change messages, please
refer to “MIDI Implementation” (Parameter List).
Pitch Bend: Pitch Bend
Aftertouch: Aftertouch
Arp Style: Arpeggio Style
Arp Grid: Arpeggio Grid
Arp Duration: Arpeggio Duration
Arp Motif: Arpeggio Motif
Chord Form: Chord Form
Master Level: The volume of the entire Fantom-S
Switch
fig.06-18_50
For details on the setting, refer to “Selecting the Parameter
Controlled by the Realtime Controllers or D Beam Controller
(Control Setting)” (p. 91).
Switch 1/2 (Assignable Switch 1–2)
Specify the functions that will be controlled by the [ ]/[ ]
buttons.
Value
Transpose Down: Lowers the key range in semitone steps
(up to 5 semitones lower).
Transpose Up: Raises the key range in semitone steps
(up to 6 semitones higher).
Tap Tempo: Tap tempo (a tempo specified by the interval at
which you press the button).
Mono/poly: Pressed to toggle between polyphonic (POLY)
and monophonic (MONO) play of a patch.
Portamento: Portamento On/Off
Hold: Hold play On/Off
MFX1–3 Sw: Multi-effect 1–3 switch
Chorus Sw: Chorus switch
Reverb Sw: Reverb switch
Mastering Sw: Mastering switch
Loop: Loop play On/Off
Rhythm Start/Stop: Rhythm pattern playback On/Off