Roland Fantom-S88 - Manual (Page 103)

103
Modifying the Sound in Real Time
Modifying the Sound in Real Time
Control Pedal Assign
This specifies the function of each pedal connected to the PEDAL
CONTROL jacks.
Value
CC01–31, 33–95: Controller numbers 1–31, 33–95
For details on control change messages, refer to “MIDI
Implementation” (Parameter List).
BEND UP:The pitch will rise in semitone steps (maximum 4 octaves)
each time you press the pedal.
BEND DOWN:The pitch will fall in semitone steps (maximum 4
octaves) each time you press the pedal.
AFTERTOUCH:Aftertouch
OCT UP:Each pedal press raises the key range in octave steps (up to
3 octaves higher).
OCT DOWN:Each pedal press lowers the key range in octave steps
(up to 3 octaves lower).
START/STOP:The sequencer will start/stop.
PUNCH IN/OUT:Manual punch-in/out recording will start/stop.
TAP TEMPO:Tap tempo (a tempo specified by the interval at which
you press the pedal).
PROG UP: The next sound number will be selected.
PROG DOWN:The previous sound number will be selected.
FAVORITE UP:The favorite sound of the next number or bank will
be selected.
FAVORITE DOWN:The favorite sound of the previous number or
bank will be selected.
ARP/RHY SW:Switches the Arpeggio/Rhythm function on/off.
RHY START/STOP: Switch Rhythm pattern playback on/off.
CHORD SW:Chord function On/Off
Control Pedal Polarity
Selects the polarity of the pedal. On some pedals, the electrical signal
output by the pedal when it is pressed or released is the opposite of
other pedals. If your pedal has an effect opposite of what you expect,
set this parameter to “REVERSE.” If you are using a Roland pedal
(that has no polarity switch), set this parameter to “STANDARD.”
Value: STANDARD, REVERSE
Hold Pedal Polarity
Select the polarity of the Hold pedal. On some pedals, the electrical
signal output by the pedal when it is pressed or released is the
opposite of other pedals. If your pedal has an effect opposite of what
you expect, set this parameter to “REVERSE.” If you are using a
Roland pedal (that has no polarity switch), set this parameter to
“STANDARD.”
Range: STANDARD, REVERSE
Continuous Hold Pedal
This setting determines whether the HOLD PEDAL jack will provide
support for half-pedaling (ON), or not (OFF). When this is set to support
use of half-pedaling techniques, you can then connect an optional
expression pedal (DP-8, etc.), and employ pedal work to achieve even
finer control in performances in which piano tones are used.
Value: OFF, ON