Roland Fantom-S88 - Manual (Page 156)

156
Editing Songs
REPLACE: Musical data in the copy destination will be erased (i.e.,
overwritten) when the copy takes place. Only the
sequencer data of the MIDI channels specified by the
Channel parameter will be overwritten, and data of
other MIDI channels will remain.
Copy Times
Specifies the number of times that the data will be copied to the copy
destination.
Status
Selects the type of data to be copied.
Value
ALL: All types of sequencer data
NOTE: Note
P.AFT: Polyphonic Aftertouch
C.C: Controller numbers
PROG: Program numbers
C.AFT: Channel Aftertouch
BEND: Pitch Bend
EXC: System Exclusive messages
Tune: Tune Request
PTN: Pattern Call Message data
If the source track is set to “TEMPO,” the Status parameter will
not be available.
Range Min, Range Max
If you have selected “NOTE,” “P.AFT,” “C.C,” or “PROG” for the
Status parameter, specify the range. Set “Range Min” to the lowest
value of the range, and “Range Max” to the highest value of the
range.
• To copy all notes or polyphonic aftertouch data, set “Range Min”
to “C-1” and “Range Max” to“G9.” To copy C4, set “Range Min”
and “Range Max” to “C4.” To copy C3 through C4, set “Range
Min” to “C3” and “Range Max” to “C4.”
• To copy all controller numbers, set “Range Min” to “0” and
“Range Max” to “127.” To copy all program numbers, set
“Range Min” to “1” and “Range Max” to “128.” To copy number
4, set “Range Min” and “Range Max” to “4.” To copy numbers 3
through 14, set “Range Min” to “3” and “Range Max” to “14.”
MIDI Channel
Selects the MIDI channel of the data to be copied.
When you want to copy all the sequencer data, set this parameter to
“ALL.” To copy only the sequencer data of a specific MIDI channel,
select the MIDI channel.
Value: ALL, 1–16
If you set the source track to “TEMPO,” or if the Status
parameter is set to “EXC,” “TUNE” or “PTN,” the Channel
parameter will not be available.
Inserting a Blank Measure
(Insert)
This function inserts blank measures into a specified song position.
As you can set the time signature of the blank measures, this is
convenient when inserting a phrase having a different time signature
in the middle of a song.
fig.11-18_50
For details on the settings, refer to “Basic Operation for Track
Editing” (p. 151)
Track / Pattern (Source Track)
Specifies the track(s) or pattern into which blank measures will be
inserted.
Value
ALL: Phrase tracks 1–16, the beat track, and the tempo track
TRK 1–TRK 16: The specified phrase track
TEMPO: Tempo track
PTN001–PTN100: The specified pattern
Measure, For (Edit Range)
Specifies the measure location at which the blank measures are to be
inserted, and the number of blank measures to be inserted.
Beat
In general, the time signature of the measure immediately before
insertion will be used for the blank measures. To change the time
signature of the blank measures to be inserted, use the Beat
parameter.
Beat can be specified only when you have set the Track
parameter to “ALL.”
Transpose the Key (Transpose)
This transposes the pitch of notes within a specified area, over a +/-
127 semitone range. Use this function to modulate from one key to
another in a song, or to transpose the entire song.
fig.11-19_50
For details on the settings, refer to “Basic Operation for Track
Editing” (p. 151)