Roland Fantom-S88 - Manual (Page 28)

28
Playing in Patch Mode
1. Press [PATCH/RHYTHM] to access the Patch Play screen.
fig.02-00a.e
2. Press [1 (Kbd Part)] or [2 (Pad Part)] to move the cursor to
the pad part or the keyboard part.
fig.02-02.e
3. If you selected a patch group, turn the VALUE dial or use
[INC][DEC] to choose the patch group.
USER: User
PR-A–E: Preset A–E
CARD: Memory Card
GM: GM (GM2)
XP-A–D: Wave Expansion Boards installed in EXP-A–D Slots
* Make sure that the patch type select switch is set to “Patch.” If this is
set to “Rhythm,” use [CURSOR] to move the cursor to the switch, and
turn the VALUE dial or press [DEC] to select “Patch.”
With the cursor located at “Rhythm,” press [ENTER] to open the
Patch Type window. You can also use CURSOR to select “Patch” and
then press [8 (Select)] to make the selection.
4. Press [CURSOR] to move the cursor to the patch group.
5. Turn the VALUE dial, or press [INC]/[DEC] to select a patch
group.
6. If you selected a patch for the pad part, play the pads to hear
the sound. If you selected a patch for the keyboard part, play
the keyboard to hear the sound.
Selecting Favorite Patches
(Favorite Sound)
You can bring together your favorite and most frequently used
patches in one place by registering them in the Favorite sound. By
using this function, you can rapidly select favorite patches from
internal memory or a Wave Expansion Board.
If a patch stored in a Wave Expansion Board has been registered
as a Favorite Sound, it cannot be selected unless the
corresponding wave expansion board is installed.
For instructions on how to register to the Favorite Sounds, refer
to “Registering a Favorite Patch (Favorite Sound)” (p. 30).
1. Press [PATCH/RHYTHM] to access the Patch Play screen.
2. Press [4 (Favorite)].
The Favorite List window appears.
fig.02-03_50
3. Press or to choose the patch.
4. To change the bank, turn the VALUE dial or use [INC][DEC].
5. After you have changed the bank, press [1]–[8] to select a
patch.
6. Press [EXIT] to close the Favorite window
Selecting Patches from the List
You can display a list of patches and select a patch from that list.
1. Press [PATCH/RHYTHM] to access the Patch Play screen.
2. Press [3 (Patch List)].
The Patch List screen appears.
fig.02-06_50
3. Use or to select a patch.
If [6 (Categ)] has a check mark ( ✔), the list will show the
categories. If you press [6 (Categ)] to remove the check mark, the
list will show the patch groups.
Patch number
Patch name Patch group Patch type Patch Category
Patch number Patch group Patch type