Roland Fantom-S88 - Manual (Page 158)

158
Editing Songs
Changing the MIDI Channel
(Change Channel)
This function transfers the MIDI channel of a specified area of
sequencer data into a different MIDI channel.
fig.11-21_50
For details on the settings, refer to “Basic Operation for Track
Editing” (p. 151)
Track / Pattern (Source Track)
Specifies the phrase track(s) or pattern in which the MIDI channel
will be changed.
Value
ALL: Phrase Tracks 1–16
TRK 1–TRK 16: The specified phrase track
PTN001–PTN100: The specified pattern
Measure, For (Edit Range)
Specifies the range of measures in which the MIDI channel will be
changed. If you set “For” to “ALL,” all measures will be specified.
Status
Selects the type of data for which you wish to change the MIDI
channel.
Value
ALL: All following sequencer data types
NOTE: Note
P.AFT: Polyphonic Aftertouch
C.C: Controller numbers
PROG: Program numbers
C.AFT: Channel Aftertouch
BEND: Pitch Bend
Range Min, Range Max
If you have set the Status parameter to “NOTE,” “P.AFT,” “C.C,” or
“PROG,” you can specify the range of data. Set “Range Min” to the
lowest value of the range, and “Range Max” to the highest value of
the range.
• To change the MIDI channel of all notes or polyphonic
aftertouch data, set “Range Min” to “C -1” and “Range Max” to
“G9.” To change the MIDI channel of C4, set “Range Min” and
“Range Max” to “C4.” To change C3 through C4,” set “Range
Min” to “C3” and “Range Max” to “C4.”
• To change the MIDI channel of all controller numbers, set
“Range Min” to “0” and “Range Max” to “127.” To change the
MIDI channel of all program numbers, set “Range Min” to “1”
and “Range Max” to “128.” To change number 4, set “Range
Min” and “Range Max” to “4.” To change numbers 3 through 14,
set “Range Min” to “3” and “Range Max” to “14.”
Src Channel, Dst Channel (MIDI Channel)
Set Src Channel to the MIDI channel that you want to change, and
set Dst Channel to the MIDI channel to which it will be changed.
If you have selected ALL for the source MIDI channel, the sequencer
data of all MIDI channels will be combined into the destination MIDI
channel.
Value: ALL, 1–16
It is not possible to select “ALL” for the destination MIDI
channel.
Modifying the Length of Notes
(Change Duration)
This function modifies the duration (time from note-on to note-off)
of notes within a specified area. Depending on the setting, you can
also create staccato or tenuto.
fig.11-22_50
For details on the settings, refer to “Basic Operation for Track
Editing” (p. 151)
Track / Pattern (Source Track)
Specifies the phrase track(s) or pattern whose durations will be
changed.
Value
ALL: Phrase Tracks 1–16
TRK 1–TRK 16: The specified phrase track
PTN001–PTN100: The specified pattern
Measure, For (Edit Range)
Specifies the range of measures whose durations will be changed. If
you set “For” to “ALL,” all measures will be specified.
Bias
Set this parameter if you wish to increase or decrease all durations
by a fixed amount. If you want to extend all duration by 10, set this
to “+10.”
Value: -4800– +4800