Roland Fantom-S88 - Manual (Page 178)

178
Adding Effects
Applying Effects in
Performance Mode
In Performance mode you can use three multi-effects (MFX1, MFX2,
MFX3), one chorus, and one reverb. For each of the three multi-
effects, the chorus, and the reverb, you can specify whether it will
operate according to the effect settings of the performance, or
according to the effect settings of the patch or rhythm set assigned to
the part you specify. The three multi-effects can be used
independently, or you can connect two or three of them in series.
Specifying How the Sound Will Be
Output (Routing)
Here you can make overall settings for effects, and the output
destination and level of each signal.
fig.14-06.eps_50
For details on the setting, refer to “Making Effect Settings” (p. 175).
Signal Flow Diagram and Parameters
fig.14-06
Part Select
Select the part for which you want to make settings.
Value: 1–16
Part Output Assign
Specifies for each part how the direct sound will be output.
Value
MFX: Output in stereo through multi-effects. You can also apply
chorus or reverb to the sound that passes through multi-
effects.
A, B: Output to the OUTPUT A (MIX) jack or OUTPUT B jack in
stereo without passing through multi-effects.
1–4: Output to the INDIVIDUAL 1–4 jacks in mono without
passing through multi-effects.
PAT: The part’s output destination is determined by the settings of
the patch or rhythm set assigned to the part.
When the settings are such that signals are split and output from
the INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, and no plug is
inserted in the INDIVIDUAL 2 jack, the sounds from
INDIVIDUAL 1 and INDIVIDUAL 2 are mixed together, then
output from the INDIVIDUAL 1 jack. This sound comprises the
sounds from the INDIVIDUAL 1 and 2 jacks.
If the Mix/Parallel parameter is set to “MIX,” all sounds are
output from the OUTPUT A (MIX) jacks in stereo (p. 193).
• When setting the “MFX,” set the output destination with the
MFX Output Assign ( ) for the sound after it has passed
through the multi-effects.
• Chorus and reverb are output in mono at all times.
• The output destination of the signal after passing through the
chorus is set with the Chorus Output Select ( ) and the Chorus
Output Assign ( ).
• The output destination of the signal after passing through the
reverb is set with the reverb Output Assign ( ).
Part Output MFX Select
(Part Output Multi-Effects Select)
Of the three systems of multi-effects that can be used
simultaneously, specify which multi-effects will be used.
Value: 1–3(MFX-1–MFX-3)
Part Output Level
Set the level of the signal that is sent to the output destination
specified by Part Output Assign (
).
Value: 0–127
Part Chorus Send Level
Sets the level of the signal sent to chorus for each part.
Value: 0–127
Part Reverb Send Level
Sets the level of the signal sent to reverb for each part.
Value: 0–127
For the following parameters – , settings can be made
individually for three systems multi-effects (MFX1–MFX3).
1
13
10
9
8 11
7
10
9
8 11
7
10
9
8 11
7
14 15
18
12
17
16
6
5
4
2 3
19
20
21
1
2
11
13
15
18
3
4
2
5
6
7 11