Roland Fantom-S88 - Manual (Page 131)

131
Editing a Sample
Editing a Sample
Amp
This operation applies an envelope (time-variant change) to the
volume of the sample.
You can also adjust the volume of the entire sample.
* You cannot execute this with more than one sample selected.
1. Press [SAMPLE EDIT] to access the Sample Edit screen.
2. Press [3 (Sample Modify)] to access the Sample Modify
window.
3. Press [4 (Amp)].
fig.Amp_50
4. Use VALUE dial or [INC], [DEC] to set the value.
• Rate 1–4: Specifies the rate of volume boost.
This specifies how much boost will be applied relative to the
current volume. The entire sample you select will be boosted.
Value: 0–400%
5. If you want to specify a point, press [5 (Point)] to add a
check mark. Press or to select a parameter, and
then use VALUE dial or [INC], [DEC] to set the value.
• Current Point:Specifies the currently selected point. Beginning
near the start point, the points will be numbered 1, 2, 3, or 4.
• Point 1–4: Location of the current point
• Rate 1–4: Amplification ratio of the current point
Specifies how the volume of each point is to be boosted relative
to the current value.
Value: 0–400%
6. If you want the edited sample to replace the current sample,
press [6 (Over Writer)] to display the “ ✔” mark.
7. Press [8 (Exec)].
A message will ask you for confirmation.
8. To execute, press [8 (Exec)].
* To cancel, press [7 (Cancel)].
Stretching or Shrinking a
Sample (Time Stretch)
This operation stretches or shrinks the sample to modify the length
or tempo. You can stretch or shrink the sample by a factor of one half
to double the original length.
* You cannot execute this with more than one sample selected.
1. Press [SAMPLE EDIT] to access the Sample Edit screen.
2. Press [3 (Sample Modify)] to access the Sample Modify
window.
3. Press [5 (Time Strtch)].
fig.TimeStretch_50
4. Press or to select the parameter.
• Edit Time Stretch
BPM: Change the BPM (p. 116) of the sample to the BPM you
specify.
Time: Specify the length of the sample as a time value.
Rate: Specify the length relative to the current length of the
sample.
Value: 50.0–200.0%
• Type
Lower settings of this value will make the sound more suitable
for faster phrases, and higher settings will make the sound more
suitable for slower phrases.
Value: TYPE01–TYPE10
• Quality Adjust
Make fine adjustments to the tonal quality of the Time Stretch.
Value: 1–10
5. Use VALUE dial or [INC/DEC] to specify the tempo/length.
When setting the BPM (tempo) value, you can hold down
[SHIFT] and turn the VALUE dial, or use [INC] [DEC] to adjust
the value to the right of the decimal point.
6. Press [8 (Exec)].
The length of the sample will be changed as specified.
* To cancel, press [7 (Cancel)].