Roland Fantom-S88 - Manual (Page 38)

38
Playing in Patch Mode
1. Press [PATCH/RHYTHM] to access the Patch Play screen.
2. Press [1 (Kbd Part)] or [2 (Pad Part)] to select the pad part or
the keyboard part.
fig.02-15.e
* Make sure that the Patch Type is set to “Rhythm.” If this is set to
“Patch,” use [CURSOR] to move the cursor to the switch, and
turn the VALUE dial or press [INC] to select “Patch.” With the
cursor located at “Patch (Rhythm),” press [ENTER] to open the Patch
Type window. You can also use CURSOR to select “Rhythm (Patch)”
and then press [8 (Select)] to make the selection.
3. Press to move the cursor to the rhythm set group.
4. Turn the VALUE dial or press [INC]/[DEC] to select the
rhythm set group.
USER: User
PRST: Preset
CARD: Memory card
GM: Preset GM (GM2)
XP-A–D: Wave Expansion Boards installed in EXP-A–D Slots
5. Press to move the cursor to the rhythm set number.
6. Turn the VALUE dial or press [INC]/[DEC] to select the
rhythm set number.
7. If you selected a rhythm set for the pad part, play the pads to
hear the sound. If you selected a rhythm set for the
keyboard part, play the keyboard to hear the sound.
You can select favorite rhythm sets in the same way as when
selecting patches. For details on the procedure, refer to
“Selecting Favorite Patches (Favorite Sound)” (p. 28).
Playing a Rhythm Set
1. Press [PATCH/RHYTHM] to access the Patch Play screen,
and then press [7].
The Patch Play screen switches.
2. Press [1 (Kbd Part)] or [2 (Pad Part)] to select the part. Select
the rhythm set that you wish to play.
3. Press a key or a pad on the keyboard to play a percussion
instrument.
Below the rhythm set name, the screen shows the note name of
the key you pressed, and the name of the percussion instrument
(rhythm tone name) assigned to that key.
fig.02-16.e
Rhythm set number Rhythm set group
Patch Type
Note name
Rhythm tone name