Roland Fantom-S88 - Manual (Page 85)

85
Creating a Performance
Creating a Performance
Mute Switch
Temporarily mutes ( ✔) or releases the mute (OFF) for the
Performance of each part.
Use this setting when, for example, you want to use the instrument
for karaoke by muting the part playing the melody, or when you
want to play something using a separate sound module.
Value: OFF, ON ( ✔)
The Mute Switch parameter does not turn the part off, but sets
the volume to minimum so that no sound is heard. Therefore,
MIDI messages are still received.
Part Level
Adjust the volume of each part. This setting’s main purpose is to
adjust the volume balance between parts.
Value: 0–127
Part Pan
Adjust the pan of each part. “L64” is far left, “0” is center, and “63R”
is far right.
Value: L64–0–63R
[2 (Output Effect)]
fig.06-20_50
For details on the setting, refer to “Adjusting the Parameters of
Each Part” (p. 84).
Part Output Assign
Specifies for each part how the direct sound will be output.
Value
MFX: Output in stereo through multi-effects. You can also apply chorus
or reverb to the sound that passes through multi-effects.
A, B: Output to the OUTPUT A (MIX) jack or OUTPUT B jack in
stereo without passing through multi-effects.
1–4: Output to the INDIVIDUAL 1–4 jacks in mono without
passing through multi-effects.
PAT: The part’s output destination is determined by the settings of
the patch or rhythm set assigned to the part.
When the settings are such that signals are split and output from
the INDIVIDUAL 1 jack and INDIVIDUAL 2 jack, and no plug is
inserted in the INDIVIDUAL 2 jack, the sounds from
INDIVIDUAL 1 and INDIVIDUAL 2 are mixed together, then
output from the INDIVIDUAL 1 jack. This sound comprises the
sounds from the INDIVIDUAL 1 and 2 jacks.
If the Mix/Parallel parameter is set to “MIX,” all sounds are
output from the OUTPUT A (MIX) jacks in stereo (p. 193).
• When setting the “MFX,” set the output destination with the
MFX Output Assign for the sound after it has passed through the
multi-effects.
• Chorus and reverb are output in mono at all times.
• The output destination of the signal after passing through the
chorus is set with the Chorus Output Select and the Chorus
Output Assign.
• The output destination of the signal after passing through the
reverb is set with the reverb Output Assign.
Part Output MFX Select
(Part Output Multi-Effects Select)
Of the three types of multi-effects that can be used simultaneously,
specify which multi-effects will be used.
Value: 1–3 (MFX-1–MFX-3)
Part Output Level
Set the level of the signal that is sent to the output destination
specified by Part Output Assign.
Value: 0–127
Part Chorus Send Level
Sets the level of the signal sent to chorus for each part.
Value: 0–127
Part Reverb Send Level
Sets the level of the signal sent to reverb for each part.
Value: 0–127
MFX1–3 Source
Chorus Source
Reverb Source
The settings of a specific patch can be used as the settings for MFX1
(1)–MFX3 (3), chorus (C), and reverb (R). This setting specifies the
part to which this patch has been assigned.
If no part is selected, the settings of the Performance will be used.
For the following parameters, settings can be made individually
for each multi-effects (MFX1–MFX3) selected in Part Output
MFX Select.