Roland Fantom-S88 - Manual (Page 92)

92
Creating a Performance
Control Knob (Control Knob Switch)
Specifies whether each part will be controlled by the control knob.
Value: OFF, ON
Make Settings for the Realtime
Controllers and D Beam Controller
(Ctrl)
fig.06-11_50
For details on the setting, refer to “Selecting the Parameter
Controlled by the Realtime Controllers or D Beam Controller
(Control Setting)” (p. 91).
D Beam (Pad Trigger)
Instead of striking the pads themselves, you can also use the D Beam
controller to control the sounding of the pads.
Settings for the PAD trigger are saved independently for each
performance as part of the performance settings. This lets you
create performances that make effective use of controller
settings.
Pad Number
Specifies the pad number affected by the D Beam.
Value: 1–16
Pad Velocity
Specifies the strength of the pad sound played by the D Beam
controller.
Value: 1–127
Pad Control Mode
This specifies how the D Beam will behave when it is obstructed. If
this is set to MOMENTARY, the parameter will be on only while the
D Beam is obstructed, and will turn off when you stop obstructing it.
If this is set to LATCH, the parameter will alternately be switched
on/off each time you obstruct the D Beam.
Value: MOMENTARY, LATCH
D Beam (Solo Synth)
You can use the D Beam controller to perform in a way similar to on
a mono synth.
fig.06-12_50
For details on the setting, refer to “Selecting the Parameter
Controlled by the Realtime Controllers or D Beam Controller
(Control Setting)” (p. 91).
When you press [7 (Panel View)], the Panel View screen will
appear, which displays the above parameters in graphical
fashion, simulating an analog synthesizer. From the Panel View
screen, you can press [2 (Image View)] to open the Image View
screen, where you can see a graphical indication of the D Beam
output value. Press [EXIT] to leave this screen.
To exit from this screen, press [EXIT].
Settings for the Solo Synth are saved for system settings.
OSC 1/2 Waveform
Select the waveform. SAW is a sawtooth wave, and SQR is a square
wave.
OSC 1/2 Pulse Width
Specifies the pulse width of the waveform. By cyclically modifying
the pulse width you can create subtle changes in the tone.
* The Pulse Width is activated when “SQR” is selected with OSC1/2
waveform.
Value: 0–127
OSC 1/2 Coarse Tune
Adjusts the pitch of the tone’s sound up or down in semitone steps
(+/-4 octaves).
Value: -48–+48
OSC 1/2 Fine Tune
Adjusts the pitch of the tone’s sound up or down in 1-cent steps (+/-
50 cents).
Value: -50–+50
OSC2 Level
Adjust the level.
Value: 0–127