beautypg.com

Show commands, C-25, Table c-13, show commands – Paradyne CSU User Manual

Page 407: Table c-13, show, Commands

background image

C. Router CLI Commands, Codes, and Designations

9128-A2-GB20-80

September 2002

C-25

Show Commands

Show commands allow you to display information.

Table C-13. Show Commands (1 of 4)

show

arp

Minimum Access Level: Operator
Command Mode: Standard

Displays the devices in the ARP table.

The general format of the

show arp

command is:

The first column displays the IP address. The second column displays the actual time left
for the specific entry, or “STATIC” for configured static entries. The third column displays
the MAC address for the ARP entry. The fourth column displays the ARP type (only ARPA
is currently supported). The fifth column displays the Interface or sub-interface for the
ARP table entry.

show

bridge

Minimum Access Level: Operator
Command Mode: Standard

Displays entries in the bridge forwarding database.

show

configuration

Minimum Access Level: Operator
Command Mode: Standard

Displays/outputs a sequence of commands in the form of ASCII strings that have the
effect of setting all configurable parameters to the current values in memory.

Passwords are write-only and not output. The text file can be used with a terminal
emulation program. Refer to

Configuring the Router Using Terminal Emulation

in

Chapter 5,

Configuring the FrameSaver SLV Router.

The general format of the

show config

command is:

global commands

!
interface n

interface n commands....

!

interface n sub-interface n
interface n sub-interface n commands...

!

interface n sub-interface n+1

interface n sub-interface n+1 commands...
interface n+1

IP Address

Timeout (min)

MAC address

Type

Interface

x.x.x.x

STATIC

xx:xx:xx:xx:xx:xx

ARPA

x.x.x.x

time

xx:xx:xx:xx:xx:xx

ARPA

Interface

This manual is related to the following products: