Paradyne CSU User Manual
Page 31
2. User Interface and Basic Operation
9128-A2-GB20-80
September 2002
2-3
FrameSaver units support two sessions simultaneously. If two sessions are
currently active, wait and try again.
T
If two sessions are currently active and you are attempting to access the unit
through Telnet, the local Telnet client process returns a
Connection
refused:
message at the bottom of the screen.
T
If two sessions are currently active and you are attempting to access the unit
over the COM port or modem port, not via Telnet, the User Interface Already In
Use screen is redisplayed. In addition, the type of connection (Telnet
Connection, Direct COM Port Connection, or Direct Modem Port Connection)
for each current user is identified, along with the user’s login ID.
Procedure
To end the session:
1. Press Ctrl-a to switch to the function keys area of the screen.
2. Type e (Exit) and press Enter.
— For a terminal-connected to the COM port, the session is ended.
— For a terminal-connected to the modem port, the session is ended and the
modem is disconnected.
— For a Telnet connection, the session is closed and, if no other Telnet or
FTP session is occurring over the connection, the modem is
disconnected.
If ending a session from the Configuration branch, see
If your login was . . .
Then the . . .
Valid
Main Menu
appears. Begin your session.
NOTE: If your login is valid, but access is denied, there are
two currently active sessions.
Invalid
Message,
Invalid Password
, appears on line 24, and
the Login screen is redisplayed.
After three unsuccessful attempts:
T
A Telnet session is closed.
T
The User Interface Idle screen appears for a directly
connected terminal.
T
The internal modem connection is disconnected.
T
An SNMP trap is generated.
Access is denied.
See your system administrator to verify your login (Login
ID/Password combination).