Turning off the system alarm relay – Paradyne CSU User Manual
Page 263
7. Operation and Maintenance
9128-A2-GB20-80
September 2002
7-81
Turning Off the System Alarm Relay
For carrier-mounted FrameSaver units, an alarm system relay is provided by the
9000 Series Access Carrier. This relay activates a light or buzzer when an alarm
condition is detected in one of the FrameSaver units.
Once the alarm relay is connected, enabling the System Alarm Relay option
activates this feature (see
Table 4-5, General System Options,
Once activated, the relay is turned off in one of the following ways:
T
The alarm condition that activated the relay no longer exists. The relay stays
on until all alarm conditions have been corrected.
T
The System Alarm Relay option can be disabled.
Main Menu
→
Configuration
→
System
→
General
T
System Alarm Relay Cut-Off can be selected.
Main Menu
→
Control
→
System Alarm Relay Cut-Off
See
Alarm Relay Connector in the
9000 Series Access Carrier Installation
for information about connecting the alarm relay.