Paradyne CSU - Manual (Page 201)

7. Operation and Maintenance
9128-A2-GB20-80 September 2002 7-19
System and Test Status Messages
System and test status information is selected from the Status menu.
Main Menu
→
Status
→
System and Test Status
The following information is included on this screen:
T Self-Test Results Messages ( Table 7-7 )
T Last System Reset Date and Time
T Health and Status Messages ( Table 7-8 )
T Test Status Messages ( Table 7-9 )
Self-Test Results Messages
One of these self-test result messages appears in the Self-Test Results field at the
top of the System and Test Status screen.
Last System Reset Date and Time
This field indicates the last time the FrameSaver unit was reset. It appears after
the Self-Test Results field at the top of the System and Test Status screen.
T Date is in mm/dd/yyyy format (month/day/year).
T Time is in mm:ss format (minutes:seconds).
Table 7-7. Self-Test Results Messages
Message What It Indicates What To Do
Failure xxxxxxxx An internal failure occurred
(xxxxxxxx represents an
8-digit hexadecimal failure
code used by service
personnel).
Record the failure code
before resetting the unit;
otherwise, the error
information will be lost.
1. Record the failure code.
2. Reset the unit.
3. Contact your service
representative.
Passed No problems were found
during power-on or reset. No action needed.