Paradyne CSU - Manual (Page 388)

C. Router CLI Commands, Codes, and Designations
C-6 September 2002 9128-A2-GB20-80
ip address ip-addr subnet-mask
no ip address [ ip-addr subnet-mask ]
Minimum Access Level: Administrator
Command Mode: config-if (Ethernet), config-subif (Serial)
Assigns an IP address to the Ethernet interface or a Serial port sub-interface. No IP
addresses are assigned to interfaces or sub-interfaces by default.
Example: ip address 132.53.4.2 255.255.255.255
Use the no ip address command to remove an IP address assigned to an interface or
sub-interface, and disable IP processing on the interface. The following rules apply:
T Each sub-interface must be assigned to a different subnet.
T A customer data IP address and subnet mask must be different from any IP address
used for management.
T When an IP address and subnet mask are assigned to an interface or sub-interface,
the device automatically creates a routing table entry with the same destination
address and subnet mask, saying that IP addresses within that range are directly
reachable on the interface. This is the
interface route .
T If the maximum number of static routes have already been configured, you cannot
assign an IP address to the interface or sub-interface.
T When an interface address and subnet mask are deleted, any routing entries with a
Next Hop Router address that fall within the interface’s address range are deleted
automatically.
ip-address – IP address of the interface or sub-interface.
subnet-mask – Subnet mask to be used when the IP address is being compared during
route table lookups. The subnet mask cannot be 0.0.0.0 and only contiguous, left-justified
subnet masks are allowed.
encapsulation encapsulation-type encapsulation-protocol
Minimum Access Level: Administrator
Command Mode: config-if (Serial)
Specifies the type of encapsulation on an interface.
Example: encapsulation frame-relay ietf
encapsulation-type – Specifies Frame Relay encapsulation on the serial interface. The
default is frame-relay.
encapsulation-protocol – Specifies RFC 1490 encapsulation protocol on the serial
interface. The default is ietf.
Table C-4. Interface Commands (2 of 3)