Ip ping test – procedure 1, Ip ping test, Procedure 1 – Paradyne CSU User Manual
Page 303
8. Troubleshooting
9128-A2-GB20-80
September 2002
8-39
IP Ping Test – Procedure 1
Procedure
To ping any far-end FrameSaver unit:
1. Select the IP Ping test.
Main Menu
→
Test
→
IP Ping
2. Enter the IP Address of the device the ping is being sent to, then select Start.
NOTE:
If the FrameSaver unit has just initialized, or the far-end unit has just
initialized, it may take about a minute for the units to learn the routes via
the proprietary RIP.
3. Verify the results of the IP Ping test.
— While the test is running,
In Progress...
appears in the Status field.
— When the test is finished,
Alive
should appear as the Status. If any
other message is displayed, additional testing is required.