Konica Minolta Polygon Editing Tool - Manual (Page 240)

238
Chapter
2
Tool
Menu
9i
910
900
700
300
n Measuring an Angle ([Angle])
Use the following procedure to measure the angle formed by three specified points on the selected ele-
ment.
Parameters Returned When Measuring an Angle ([Angle])
Angle Angle formed by the three points, in degrees. (White lines in an element view window.)
Point 1 Coordinates of the first specified point. (Yellow point in an element view window.)
Point 2 Coordinates of the second specified point. (Yellow point in an element view window.)
Point 3 Coordinates of the third specified point. (Yellow point in an element view window.)
Operating Procedure
1 Check on the [Angle].
2 Specify the first point on the element by
clicking on it.
The specified point will be displayed in an ele-
ment view window.
M emo
If you want to redo the point specifying, click the Right
mouse button at anywhere.
3 Specify the second point by clicking on
it.
M
emo
If you want to redo the point specifying, click the Right
mouse button at anywhere.
4 Specify the third point by clicking on it.
The angle defined by the three specified points
is calculated, and the calculated results will
be displayed in the upper-right window of the
[Tool – Measure] dialog box, and two lines -
connecting the first point to second point and
second point to third point - will be displayed
in an element view window.
M emo
To calculate the next angle, click the Right mouse button
on the next point.
Tool – Measure