Konica Minolta Polygon Editing Tool - Manual (Page 15)

5) Connecting the VIVID digitizer to the computer
When the VIVID digitizer will be controlled from Polygon Editing Tool, connect the VIVID digitizer to the
computer first, and then start up Polygon Editing Tool.
The first time the VIVID digitizer is connected to the computer, it is necessary for the computer to recognize
the VIVID digitizer as an external device.
Perform operations according to the following procedure.
n Connecting the VIVID digitizer to the computer
In order for the protect key to be recognized by the corresponding driver software, it is necessary to install the
driver software on the computer before connecting the protect key to the computer.
Operating Procedure
1 Turn the POWER switch of the comput-
er OFF.
2 Connect the VIVID digitizer to the com-
puter.
Memo
For details on how to connect the VIVID digitizer to the
computer, refer to the instruction manual of each model
of the VIVID digitizer.
3 Set the POWER switch of the VIVID
digitizer to ON (set switch to “I” mark).
Initializing of the digitizer will start.
4 After MENU appears in the finder of
the digitizer, switch on the computer to
start the Windows operating system.
Note
The POWER switch of the digitizer should be set to ON
first before switching on the computer.
Chapter
1
Preparations
13
0/7%2
!# ). 3#3)