Konica Minolta Polygon Editing Tool - Manual (Page 214)

212
Chapter
2
Build
Menu
9i
910
900
700
300
Build – Subdivision – Element
Rebuilding the Selected Element by Dividing Large Polygons
This command is used to rebuild the selected element by dividing large polygons.
M
emo
The element selected before execution of this command will be divided to triangular polygons.
Parameters for [Build-Subdivision-Element] Dialog Box
Maximum edge length Used to set the maximum edge length of element to be rebuilt.
Maximum face area Used to set the maximum face area of element to be rebuilt.
Operating Procedure
1 From the element list, select the desired
element.
2 From the [Build] menu, select [Subdivi-
sion] then click [Element].
The [Build-Subdivision-Element] dialog box
will appear.
• The selected element will be ready to be displayed
in all windows. It will be displayed if it is not
displayed in the active window or the windows for
which all the elements are set to be displayed.
3 Set the parameters.
4 Click the [Apply] button.
The data of the points comprising the selected
element will be rebuilt according to the param-
eter settings.
• The polygons comprising the selected element
will be triangulated.
• If you change the parameter settings and click the
[Apply] button again, the data for the selected ele-
ment will be rebuilt according to the new param-
eter settings.
5 Click the [OK] button.
This will confirm execution of data rebuilding
and close the dialog box.