SMC Networks TIGERSWITCH 10/100 - Manual (Page 70)

C
ONFIGURING THE
S
WITCH
2-38
Web – Click Port, Mirror. Specify the source port, the traffic type to
be mirrored, and the monitor port, then click Add.
CLI – Use the interface command to select the monitor port, then
use the port monitor command to specify the source port. Note
that default mirroring under the CLI is for both received and
transmitted packets.
Address Table Settings
Switches store the addresses for all known devices. This
information is used to route traffic directly between the inbound
and outbound ports. All the addresses learned by monitoring
traffic are stored in the dynamic address table. You can also
manually configure static addresses that are bound to a specific
port.
Console(config)#interface ethernet 1/10 3-89
Console(config-if)#port monitor ethernet 1/13 3-148
Console(config-if)#