Switchport mode, Switchport mode -125 – SMC Networks TIGERSWITCH 10/100 User Manual
Page 267
VLAN C
OMMANDS
3-125
Example
The following example shows how to set the interface
configuration mode to VLAN 1, and then assign an IP address to
the VLAN:
Related Commands
switchport mode
Use this command to configure the VLAN membership mode for a
port. Use the no form to restore the default.
Syntax
switchport mode {trunk | access}
no switchport mode
• trunk - Specifies a port as an end-point for a VLAN trunk. A
trunk is a direct link between two switches, so the port
transmits tagged frames that identify the source VLAN.
However, note that frames belonging to the port’s default
VLAN (i.e., associated with the PVID) are sent untagged.
• access - Sets the port to operate as an untagged interface. All
frames are sent untagged.
Default Setting
All ports are in access mode with the PVID set to VLAN 1.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#