SMC Networks TIGERSWITCH 10/100 - Manual (Page 167)

F
LASH
/F
ILE
C
OMMANDS
3-25
Example
This example shows the information displayed by the whichboot
command. See the table under the dir command for a description
of the file information displayed by this command.
boot system
Use this command to specify the file or image used to start up the
system.
Syntax
boot system {boot-rom| config | opcode}: filename
The type of file or image to set as a default includes:
• boot-rom - Boot ROM
• config - Configuration file
• opcode - Run-time operation code
The colon (:) is required.
- filename - Name of the configuration file or image name.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• A colon (:) is required after the specified file type.
• If the file contains an error, it cannot be set as the default file.
Console#whichboot
file name file type startup size (byte)
----------------- -------------- ------- -----------
diag_0060 Boot-Rom image Y 111360
run_0200 Operation Code Y 1083008
startup Config File Y 2710
Console#