SMC Networks TIGERSWITCH 10/100 - Manual (Page 283)

GVRP
AND
B
RIDGE
E
XTENSION
C
OMMANDS
3-141
Default Setting
Disabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
GVRP can only be enabled for tagged ports. You must set
switchport mode to “trunk” to configure a tagged port.
Example
Related Commands
switchport mode (3-125)
show gvrp configuration
Use this command to show if GVRP is enabled.
Syntax
show gvrp configuration [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-4)
Default Setting
Shows both global and interface-specific configuration.
Command Mode
Normal Exec, Privileged Exec
Console(config)#interface ethernet 1/1
Console(config-if)#switchport gvrp
Console(config-if)#