SMC Networks TIGERSWITCH 10/100 - Manual (Page 219)

L
INE
C
OMMANDS
3-77
speed
Use this command to set the terminal line's baud rate. This
command sets both the transmit (to terminal) and receive (from
terminal) speeds. Use the no form to restore the default setting.
Syntax
speed bps
no speed
bps - Baud rate in bits per second.
(Options: 9600, 57600, 38400, 19200, 115200 bps)
Default Setting
9600 bps
Command Mode
Line Configuration
Command Usage
Set the speed to match the baud rate of the device connected
to the serial port. Some baud rates available on devices
connected to the port might not be supported. The system
indicates if the speed you selected is not supported.
Example
To specify 57600 bps, enter this command:
Console(config-line)#speed 57600
Console(config-line)#