SMC Networks TIGERSWITCH 10/100 User Manual
Page 68
C
ONFIGURING
THE
S
WITCH
2-36
Web – Click Port, Port Broadcast Control or Trunk Broadcast
Control. Set the threshold for each port or trunk, and then click
Apply.
CLI – Specify an interface, and then enter the threshold. The
following sets broadcast suppression at twenty percent of the port
bandwidth for Port 3.
Console(config)#interface ethernet 1/3
Console(config-if)#switchport broadcast percent 20
Console(config-if)#end
Console#show interface switchport ethernet 1/3
Information of Eth 1/3
Broadcast threshold: Enabled, 20 percent
Ingress rate limit: Disabled
Egress rate limit: Disabled
VLAN membership mode: Access
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled
Allowed Vlan:
1(u),
Forbidden Vlan:
Private-vlan mode: NONE
Private-vlan host-association: NONE
Private-vlan mapping: NONE
Console#