SMC Networks TIGERSWITCH 10/100 - Manual (Page 285)

GVRP
AND
B
RIDGE
E
XTENSION
C
OMMANDS
3-143
experiencing difficulties with GMRP or GVRP registration/
deregistration.
• Timer values are applied to GVRP for all the ports on all VLANs.
• Timer values must meet the following restrictions:
- leave >= (2 x join)
- leaveall > leave
Note: Set GVRP timers on all Layer 2 devices connected in the
same network to the same values. Otherwise, GVRP will
not operate successfully.
Example
Related Commands
show garp timer (3-143)
show garp timer
Use this command to show the GARP timers for the selected
interface.
Syntax
show garp timer [interface]
interface
• ethernet unit/port
- unit - This is device 1.
- port - Port number.
• port-channel channel-id (Range: 1-4)
Default Setting
Shows all GARP timers.
Console(config)#interface ethernet 1/1
Console(config-if)#garp timer join 100
Console(config-if)#