SMC Networks TIGERSWITCH 10/100 - Manual (Page 248)

C
OMMAND
L
INE
I
NTERFACE
3-106
Example
This example sets the rate limit for input and output traffic on port
2 to 312K when operating at 10 Mbps or 3.12 Mbps when
operating at 100 Mbps.
Address Table Commands
These commands are used to configure the address table for
filtering specified addresses, displaying current entries, clearing the
table, or setting the aging time.
Console(config)#
Console(config)#interface ethernet 1/2
Console(config-if)#rate-limit input percent 3
Console(config-if)#rate-limit output percent 3
Console(config)#
Command Function Mode Page
mac-address-table
static Maps a static address to a port in a
VLAN GC 3-107
clear
mac-address-table
dynamic Removes any learned entries from the
forwarding database PE 3-108
show
mac-address-table Displays entries in the
bridge-forwarding database PE 3-109
mac-address-table
aging-time Sets the aging time of the address table GC 3-110
show
mac-address-table
aging-time Shows the aging time for the address
table PE 3-111