SMC Networks TIGERSWITCH 10/100 - Manual (Page 207)

IGMP S
NOOPING
C
OMMANDS
3-65
Command Usage
The switch must be using IGMPv2 for this command to take
effect.
Example
The following shows how to configure the default timeout to 300
seconds:
Related Commands
ip igmp snooping version (3-65)
ip igmp snooping version
Use this command to configure the IGMP snooping version. Use
the no form to restore the default.
Syntax
ip igmp snooping version {1 | 2}
no ip igmp snooping version
• 1 - IGMP Version 1
• 2 - IGMP Version 2
Default Setting
IGMP Version 2
Command Mode
Global Configuration
Command Usage
• All systems on the subnet must support the same version. If
there are legacy devices in your network that only support
Version 1, you will also have to configure this switch to use
Version 1.
Console(config)#ip igmp snooping router-port-expire-time 300
Console(config)#