SMC Networks SMC TigerStack 1000 SMC8748M - Manual (Page 97)

B
ASIC
C
ONFIGURATION
3-41
therefore remember to save the current configuration after
renumbering the stack.
• For a line topology, the stack is numbered from top to bottom, with
the first unit (i.e., the unit with no connection on the Up port) in the
stack designated as unit 1. For a ring topology, the Master unit taken as
the top of the stack and is numbered as unit 1 and all other units are
numbered sequentially down through the ring.
Web – Click System, Renumbering.
Figure 3-19 Renumbering the Stack
CLI – Use the reload command to restart the switch.
Resetting the System
Web – Click System, Reset. Click the Reset button to restart the switch.
When prompted, confirm that you want to reset the switch.
Figure 3-20 Resetting the System
CLI – Use the reload command to restart the switch.
Note: When restarting the system, it will always run the Power-On
Self-Test.
Console#switch all renumber 4-33
Console#
Console#reload 4-29
System will be restarted, continue ?