SMC Networks SMC TigerStack 1000 SMC8748M - Manual (Page 535)

P
RIORITY
C
OMMANDS
4-263
Default Setting
Weights 1, 2, 4, 6, 8, 10, 12, 14 are assigned to queues 0 - 7 respectively.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
WRR controls bandwidth sharing at the egress port by defining
scheduling weights.
Example
This example shows how to assign WRR weights to each of the priority
queues for port 5.
Related Commands
show queue bandwidth (4 -265)
queue cos-map
This command assigns class of service (CoS) values to the priority queues
(i.e., hardware output queues 0 - 7). Use the no form set the CoS map to
the default values.
Syntax
queue cos-map queue_id [cos1 ... cosn]
no queue cos-map
• queue_id - The ID of the priority queue.
Ranges are 0 to 7, where 7 is the highest priority queue.
• cos1 .. cosn - The CoS values that are mapped to the queue ID. It is
a space-separated list of numbers. The CoS value is a number from
0 to 7, where 7 is the highest priority.
Console#configure
Console(config)#int eth 1/5
Console(config-if)#queue bandwidth 1 3 5 7 9 11 13 15
Console(config-if)#