Motorola MVME1X7P - Manual (Page 172)

2-82 Computer Group Literature Center Web Site
VMEchip2
2
Local Bus Interrupter Enable Register (bits 16-23)
This register is the local bus interrupter enable register. When an enable bit
is high, the corresponding interrupt is enabled. When an enable bit is low,
the corresponding interrupt is disabled. The enable bit does not clear
edge-sensitive interrupts or prevent the flip-flop from being set. If
necessary, edge-sensitive interrupters should be cleared to remove any old
interrupts and then re-enabled.
ELM0 Enable GCSR LM0 interrupt.
ELM1 Enable GCSR LM1 interrupt.
ESIG0 Enable GCSR SIG0 interrupt.
ESIG1 Enable GCSR SIG1 interrupt.
ESIG2 Enable GCSR SIG2 interrupt.
ESIG3 Enable GCSR SIG3 interrupt.
EDMA Enable DMAC interrupt.
EVIA VMEbus interrupter acknowledge interrupt.
ADR/SIZ $FFF4006C (8 bits of 32)
BIT 23 22 21 20 19 18 17 16
NAME EVIA EDMA ESIG3 ESIG2 ESIG1 ESIG0 ELM1 ELM0
OPER R/W R/W R/W R/W R/W R/W R/W R/W
RESET 0 PSL 0 PSL 0 PSL 0 PSL 0 PSL 0 PSL 0 PSL 0 PSL