FUJITSU CAN-Motor Board MB91F267N - Manual (Page 58)

AN07-00180-3E
- 58 -
2.2.5 Running the debugger
As shown in “Figure 2-34 Setting break points”, you can set break points to lines with a green round mark
on the left side in the source file. Note that you cannot set break points while the program is running.
Figure 2-34 Setting break points
As shown in “Figure 2-35 Running the program”, click the “Run Continuously” icon to run the program.
Figure 2-35 Running the program
Click this to set a break point.
To cancel the break point, click this again.