Figure 2-20 completing the build, Figure 2-21 changing the debug settings – FUJITSU CAN-Motor Board MB91F267N User Manual

Page 50

AN07-00180-3E

- 50 -

The message pane at the bottom of the window shows a message as shown in “Figure 2-20 Completing

the build”. A warning is displayed but the build has been successfully ended. (The warning indicates no

problem.)

Figure 2-20 Completing the build

Then, configure the debug settings. As shown in “Figure 2-21 Changing the debug settings”, expand

“Debug”, select “mon_38400.sup”, and then right-click on it. A menu appears; click “Change Settings”.

Figure 2-21 Changing the debug settings