IEI Integration DM_Series v1.14 - Manual (Page 149)

DM Series Industrial Monitor
Page
149
Figure 5-25: Monitor Stand Mounting
5.5.6 Monitor Arm Installation
The DM series industrial monitor has Video Electronics Standards Association (VESA)
standard mounting holes tapped into the rear panel. The standard holes are M4 set at
100m x 100mm apart (Figure 5-24). The monitor arm mounting plate has a matching
VESA hole pattern. To mount the DM series industrial monitor onto a monitor arm, please
follow the steps below.
Step 1: Line up the threaded holes on the monitor rear panel with the screw holes on the
monitor arm mounting plate.
Step 2: Secure the monitor to the arm with the supplied retention screws (Figure 5-26).
Step 0: