IEI Integration DM_Series v1.14 - Manual (Page 134)

DM Series Industrial Monitor
Page 134
5.5 Mounting the DM Series Industrial Monitor
The DM series industrial monitor can be mounted in a panel, cabinet, rack, DIN rail or wall.
The monitor can also be mounted on a monitor arm or stand. The mounting methods are
described below.
CAUTION:
When mounting the monitor take care to tighten the retention screws or bolts
until fully secure, but do not over tighten. Over tightening the retention screws
or bolts may cause them to become stripped, rendering them useless.
5.5.1 Panel Mounting
5.5.1.1 Standard Panel Mounting
The standard panel mounting procedure applies to the following DM series industrial
monitors:
„ DM-190
„ DM-170
„ DM-150
„ DM-121
„ DM-104
„ DM-84
To mount the DM series industrial monitor into a panel, please follow the steps below.
Step 1: Select the position on the panel to mount the monitor.
Step 2: Cut out a section of the panel that corresponds to the rear panel dimensions of
the monitor. Take care that the panel section that is cut out is smaller than the
overall size of the metal frame that surrounds the monitor but just large enough
for the rear panel of the monitor to fit through (Figure 5-8).