HP 2910AL - Manual (Page 91)

Using the ProCurve Web Browser Interface
Tasks for Your First ProCurve Web Browser Interface Session
This window is the launching point for the basic configuration you need to
perform to set web browser interface passwords for maintaining security and
a fault detection policy, which determines the types of messages that the Alert
Log displays.
To set web browser interface passwords, click on secure access to the device
to display the Device Passwords screen, and then go to the next page. (You
can also access the password screen by clicking on the
Security tab.)
To set Fault Detection policy, click on select the fault detection configuration in
the second bullet in the window and go to the section, “Setting Fault Detection
Policy” on page 5-24. (You can also access the password screen by clicking on
the
Configuration tab, and then the [Fault Detection] key.)
Security: Creating Usernames and Passwords
in the Browser Interface
N o t e On the switches covered in this guide you can also configure RADIUS authen­
tication for web browser interface access. For more information, refer to the
chapter titled “RADIUS Authentication and Accounting” in the Access Secu­
rity Guide
for your switch.
You may want to create both a username and a password to create access
security for your switch. There are two levels of access to the interface that
can be controlled by setting user names and passwords:
■ Operator Setting. An Operator-level user name and password allows
read-only access to most of the web browser interface, but prevents
access to the Security window.
■ Manager Setting. A Manager-level user name and password allows full
read/write access to the web browser interface.
5-9