HP 2910AL - Manual (Page 595)

Monitoring Resources
Viewing Information on Resource Usage
■ ACLs
■ QoS configurations that use the following commands:
• QoS device priority (IP Address) through the CLI using the qos
device-priority command
• QoS application port through the CLI using qos tcp-port or qos udp-port
■ Management VLAN configuration
■ DHCP snooping
■ Dynamic ARP protection
■ Jumbo IP-MTU
Resource usage on the following features, which are configured per-port,
applies only to the port group on which the feature is configured:
■ ACLs or QoS applied per-port through RADIUS authentication
■ Virus throttling applied to any port (when a high connection-rate client is
being throttled or blocked)
Displaying Current Resource Usage
To display current resource usage in the switch, enter the show qos resources
or show access-list resources command.
Syntax: show resources
Displays the resource usage of the Policy Enforcement Engine on the
switch by software feature. For each type of resource, the amount still
available and the amount used by each software feature is shown.
The qos and access-list parameters display the same command output.
The show resources command output allows you to view
current resource usage and, if necessary, help prioritize and reconfigure
software features to free resources reserved for less important features.
Figure E-1 shows the resource usage on a switch configured for ACLs, QoS,
E-3