Copying command output to a destination device – HP 2910AL User Manual
Page 447

File Transfers
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
Copying Diagnostic Data to a Remote
Host, USB Device, PC or UNIX
Workstation
You can use the CLI to copy the following types of switch data to a text file in
a destination device:
■
Command Output: Sends the output of a switch CLI command as a file on
the destination device.
■
Event Log: Copies the switch’s Event Log into a file on the destination
device.
■
Crash Data: software-specific data useful for determining the reason for
a system crash.
■
Crash Log: Processor-Specific operating data useful for determining the
reason for a system crash.
The destination device and copy method options are as follows (CLI key word
is in bold):
■
Remote Host via
TFTP.
■
Physically connected USB flash drive via the switch’s
USB port.
■
Serially connected PC or UNIX workstation via Xmodem.
Copying Command Output to a Destination Device
Syntax: copy command-output < “cli-command” > tftp < ip-address > < filepath
filename >
copy command-output < “cli-command” > usb < filename >
copy command-output <“cli-command”> xmodem
These commands direct the displayed output of a CLI
command to a remote host, attached USB device, or to a serially
connected PC or UNIX workstation.
For example, to use Xmodem to copy the output of
show config to a serially
connected PC:
A-35