Viewing transceiver status, Viewing transceiver status -12 – HP 2910AL User Manual
Page 226
Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
Operating Notes:
■
For each port on the switch, the command provides a real-time display
of the rate at which data is received (Rx) and transmitted (Tx) in terms
of kilobits per second (KBits/s), number of packets per second (Pkts/
s), and utilization (Util) expressed as a percentage of the total band
width available.
■
The
show interfaces
current link status and the port rate average over a 5 minute period.
Port rates are shown in bits per second (bps) for ports up to 1 Gigabit;
for 10 Gigabit ports, port rates are shown in kilobits per second
(Kbps).
Viewing Transceiver Status
The
show tech transceivers command allows you to:
■
Remotely identify transceiver type and revision number without having
to physically remove an installed transceiver from its slot.
■
Display real-time status information about all installed transceivers,
including non-operational transceivers.
Figure 10-7 shows sample output from the
show tech transceivers command.
ProCurve# show tech transceivers
Transceiver Technical Information:
Port # | Type | Prod # | Serial #
| Part #
-------+-----------+--------+------------------+----------
21
| 1000SX | J4858B | CN605MP23K |
22
| 1000LX | J4859C | H117E7X
| 2157-2345
23
| ??
| ?? | non operational |
25
| 10GbE-CX4 | J8440A | US509RU079 |
26
| 100FX-sfp | J9054B | CN702ZM043 | 1990-3613
27
| 10GbE-LR | J8437B | PPA02-2904:0017 | 2157-2345
28
| 10GbE-SR | J8436B | 01591602
| 2158-1000
29
| 10GbE-ER | J8438A | PPA03-2905:0001 |
The following transceivers may not function correctly:
Port #
Message
-------- -------------------------------------
Port 23
Self test failure.
Figure 10-7. Example of Show Tech Transceivers Command
10-12