HP 2910AL - Manual (Page 221)

Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
Table 10-2. Protocols and Modes Supported for Copper Ports
10/100 Mbps Gigabit 10 Gigabit
10/100 TX 10/100/1000-T 10GBASE-CX4
Modes Settings Modes Settings Modes Settings
Auto
10HDx
100HDx
10FDx
100FDx
Auto-10 100FDx
10HDx
100HDx
10FDx
100FDX
10FDX Auto
Auto-10
Auto-100
Auto-10-100
Auto-1000
10HDx
100HDX
1000FDx 1000FDx
10HDx
100FDx
100FDx
1000FDx
10HDx
100HDx
1000FDx Auto 10 Gigabit FDx
Table 10-3. Protocols and Modes Supported for Fiber Optic Ports
100 Mbps Gigabit 10 Gigabit
Protocols 100BASE-FX
100BASE-BX10 1000BASE-SX
1000BASE-LX
1000BASE-BX10
1000BASE-LH 10GBASE-SR
10GBASE-LR
10GBASE-LRM
Modes 100HDx
100FDx Auto
1000FDx Auto
Configuring Ports
You can configure and view the port settings by using the menu.
N o t e The menu interface uses the same screen for configuring both individual ports
and port trunk groups. For information on port trunk groups, refer to Chapter
12, “Port Trunking” .
1. From the Main Menu, Select:
2. Switch Configuration...
2. Port/Trunk Settings
An example of the Menu display is shown below.
10-7