HP 2910AL - Manual (Page 533)

Troubleshooting
Debug/Syslog Operation
Displaying a Debug/Syslog Configuration
Use the show debug command to display the currently configured settings for:
■ Debug message types and Event Log message filters (severity level and
system module) sent to debug destinations
■ Debug destinations (Syslog servers or CLI session) and Syslog server
facility to be used
Syntax: show debug
Displays the currently configured debug logging destinations
and message types selected for debugging purposes. (If no
Syslog server address is configured with the
logging < syslog-ip­
addr > command, no show debug command output is displayed.)
ProCurve(config)# show debug
Debug Logging
Destination:
Logging - -
10.28.38.164
Facility=kern
Severity=warning
System module=all-pass
Enabled debug types:
event
Figure C-16. Sample Output of show debug Command
Example: In the following example, no Syslog servers are configured on the
switch (default setting). When you configure a Syslog server, debug logging is
enabled to send Event Log messages to the server. To limit the Event Log
C-45