HP 2910AL - Manual (Page 448)

File Transfers
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Indicates the operation is finished.
Figure A-13. Example of Sending Command Output to a File on an Attached PC
N o t e The command you specify must be enclosed in double-quote marks.
Copying Event Log Output to a Destination Device
Syntax: copy event-log tftp < ip-address > < filepath_filename >
copy event-log usb < filename >
copy event-log xmodem <filename>
These commands copy the Event Log content to a remote host,
attached USB device, or to a serially connected PC or UNIX
workstation.
For example, to copy the event log to a PC connected to the switch:
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-14. Example of Sending Event Log Content to a File on an Attached PC
Copying Crash Data Content to a Destination Device
This command uses TFTP, USB, or Xmodem to copy the Crash Data content
to a destination device. You can copy individual slot information or the
management module’s switch information. If you do not specify either, the
command defaults to the management function’s data.
A-36