HP 2910AL - Manual (Page 442)

File Transfers
Transferring Switch Configurations
Syntax: boot system flash [ primary | secondary ]
boot system flash [ config < filename >
Switches boot from the designated configuration file. For more
on multiple configuration files, refer to “Multiple
Configuration Files” on page 6-23.
Syntax: reload
Reboots from the flash image currently in use.
(For more on these commands, refer to “Rebooting the Switch” on page
6-18.)
USB: Copying a Configuration File to a USB Device
To use this method, a USB flash memory device must be connected to the
switch’s USB port.
Syntax: copy startup-config usb < filename>
copy running-config usb < filename >
Uses the USB port to copy a designated configuration file from
the switch to a USB flash memory device. For more on multiple
configuration files, refer to “Multiple Configuration Files” on
page 6-23.
For example, to copy the startup configuration file to a USB flash drive:
1. Insert a USB device into the switch’s USB port.
2. Execute the following command:
Procurve# copy startup-config usb procurve-config
where procurve-config is the name given to the configuration file that
is copied from the switch to the USB device.
A-30