HP 2910AL - Manual (Page 449)

File Transfers
Copying Diagnostic Data to a Remote Host, USB Device, PC or UNIX Workstation
Syntax: copy crash-data [<slot-id> | master] tftp <ip-address> >
copy crash-data [<slot-id> | mm] usb >
copy crash-data [<slot-id>| mm] xmodem
where: slot-id = a - h, and retrieves the crash log or crash data from
the processor on the module in the specified slot.
mm Retrieves crash log or crash data from the switch’s
chassis processor. When “mm” is specified, crash
files from both management modules are copied.
These commands copy the crash data content to a remote host,
attached USB device, or to a serially connected PC or UNIX
workstation. You can copy individual slot information or the
management module (mm) switch information. If you do not
specify either, the command defaults to the mm data.
For example, to copy the switch’s crash data to a file in a PC:
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
Figure A-15.Example of Copying Switch Crash Data Content to a PC
Copying Crash Log Data Content to a Destination Device
Syntax: copy crash-log [<slot-id >| mm] tftp <ip-address>
>
copy crash-log [<slot-id> | mm] usb >
copy crash-log [<slot-id> | mm] xmodem
where: slot-id = a - h, and retrieves the crash log from
the processor on the module in the specified slot.
mm Retrieves the crash log from the switch’s
chassis processor. When mm is specified,
crash files from both management modules are
copied.
A-37