HP 2910AL - Manual (Page 464)

Monitoring and Analyzing Switch Operation
Status and Counters Data
ProCurve(config)# show system
Status and Counters - General System Information
System Name : ProCurve Switch
System Contact
:
System Location :
MAC Age Time (sec) : 300
Time Zone : 0
Daylight Time Rule : None
Software revision : T.13.XX Base MAC Addr : 001635-b57cc0
ROM Version : K.12.12 Serial Number : LP621KI005
Up Time : 51 secs Memory - Total : 152,455,616
CPU Util (%) : 3 Free : 110,527,264
IP Mgmt - Pkts Rx : 0 Packet - Total : 6750
Pkts Tx : 0 Buffers Free : 5086
Lowest : 5086
Missed : 0
Figure B-4. Example of Switch System Information
Task Monitor—Collecting Processor Data
The task monitor feature allows you to enable or disable the collection of
processor utilization data. The
task-monitor cpu command is equivalent to the
existing debug mode command “ taskusage -d”. (The taskUsageShow command
is available as well.)
When the task-monitor command is enabled, the show cpu command summa­
rizes the processor usage by protocol and system functions.
Syntax: [no] task-monitor cpu
Allows the collection of processor utilization data. Only
manager logins can execute this command. The settings are
not persistent, that is, there are no changes to the configura­
tion.
Default: Disabled
B-8