Viewing port status and configuration, Viewing port status and configuration -9 – HP 2910AL User Manual
Page 223
Port Status and Configuration
Viewing Port Status and Configuring Port Parameters
flow-control
broadcast-limit
auto-mdix
Viewing Port Status and Configuration
Use the following commands to display port status and configuration data.
Syntax: show interfaces [ brief | config | < port-list >]
brief: Lists the current operating status for all ports on the
switch.
config: Lists a subset of configuration data for all ports on the
switch; that is, for each port, the display shows whether the port
is enabled, the operating mode, and whether it is configured
for flow control
.
< port-list >: Shows a summary of network traffic handled by the
specified ports.
An example of the
show interfaces brief command is shown below.
ProCurve(config)# show interfaces brief
Status and Counters - Port Status
| Intrusion
MDI
Flow Bcast
Port Type
| Alert Enabled Status Mode
Mode Ctrl Limit
----- --------- + --------- ------- ------ ---------- ----- ----- ------
1
100/1000T | No
Yes Down Auto-10-100 Auto off
0
2
100/1000T | No
Yes Down 1000FDx Auto off
0
3
100/1000T | No
Yes Down 1000FDx Auto off
0
4
100/1000T | No
Yes Down 1000FDx Auto off
0
5
100/1000T | No
Yes Down 1000FDx Auto off
0
6
100/1000T | No
Yes Down 1000FDx Auto off
0
Figure 10-3. Example of show interfaces brief Command Listing
Use the
show interfaces config command to view the port settings, as shown
below.
10-9