HP 2910AL - Manual (Page 536)

Troubleshooting
Debug/Syslog Operation
ProCurve# config
ProCurve(config)# logging 10.38.64.164
ProCurve(config)# show debug
Debug Logging
Destination:
Logging --
10.38.64.164
Facility=user
Severity=debug
System module=all-pass
Enabled debug types:
event
ProCurve(config)# no debug event
ProCurve(config)# debug acl
ProCurve(config)# debug destination session
ProCurve(config)# show debug
Debug Logging
Destination:
Logging --
10.38.64.164
Facility=user
Severity=debug
System module=all-pass
Session
Enabled debug types:
acl log
Configure a Syslog server IP address.
(No other Syslog servers are
configured on the switch.) The server
address serves as an active debug
destination for any configured debug
types.)
Display the new debug configuration.
(Default debug settings - facility,
severity, system module, and debug
types- are displayed.)
Remove the unwanted event
message logging to debug
destinations.
Configure the debug messages types
that you want to send to the Syslog
server and CLI session.
Configure the CLI session as a debug
destination.
Display the final debug and Syslog
server configuration.
Figure C-18. Debug/Syslog Configuration for Multiple Debug Types and Multiple
Destinations
C-48