Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 83)

OMS OMNEO Main Station Status | Network menu | en 83
Bosch Security Systems, LLC Technical Manual 01-2021 | 03 | F.01U.380.820
No errors detected
Tx Power Field
The Tx Power field displays the amount of power used to transmit the outgoing optical signal.
Rx Power Field
The Rx Power field displays the amount of power being received from the incoming optical
signal.
14.3 OMNEO (RJ45)
The OMNEO (RJ45) screen is used to view the OMNEO (RJ45) network status.
Figure 14.4: Status | Network | OMNEO (RJ45)
Link A Column
The Link A column displays the link status, connection speed, and duplex status for the Link A
OMNEO (RJ45) connection.
Link B Column
The Link B column displays the link status, connection speed, and duplex status for the Link B
OMNEO (RJ45) connection.
Link Up Field
The Link Up field displays the status of data communication on the OMNEO (RJ45) port.
Available statuses are:
The link is up
The link is not up, but an IP address is defined
No IP address is defined
Speed Field
The Speed field displays the transmission speed over the OMNEO interface.
The OMNEO interfaces support 100 Mbps and 1 Gbps.
Duplex Field
The Duplex field displays the transmit mode the OMNEO network interface is currently
operating.
Almost all Ethernet interfaces auto-negotiate to full duplex. If the interface displays half duplex
mode, this typically signifies the auto-negotiate failed, resulting in network collisions and
errors.
Available options for this field are:
Half-Duplex Can either transmit or receive, but not both simultaneously
Full-Duplex Can transmit and receive simultaneously
14.4 RVON
The RVON screen is used to view the status of the RVON network status.